[Product Features]
This is a tabletop embroidery stand on which you can set your usual round frames.
You can embroider easily with both hands without the need to hold the frame.
The angle can be freely adjusted, and it can be tilted to the back of the frame.
　The angle can be adjusted freely, and it can be tilted to the back side, making it convenient for backside processing.
The wooden handle is equipped with a screw handle for ease of use.
　The wooden handle on the screw handle makes it easy to use.
This model is export specification with convenient items pre-installed.
[Accessories] Standard grip, thick frame grip, extra thick grip,
　　　　　 1 thread winder stand / 2 wooden round handles
　　　　　Embroidery frame is not included.
The stand head can be removed for compact storage.
There is a hole for a thread winder stand on the stand base.

[About the embroidery frame set]
The frame can be set from 8cm to 20cm in diameter.
Please replace the attached 3 types of grips depending on the thickness of the round frame.
　Please use it by replacing the three types of grips provided depending on the thickness of the round frame.
　1. Standard grip ⇒For frames 7 to 12 mm thick.
　2. Thick frame grip ⇒For frames 12 to 16 mm thick
　3. Extra thick grip ⇒For frames 16 to 20 mm thick
　　　Note: The frame thicknesses shown are approximate sizes.
　　　Note: The thicker the cloth is stretched over a round frame, the thicker the frame will be.
　　　Note: The thickness will also increase when bias tape is used.
Grip is not fixed due to its structure. Please be careful not to lose it.
When using large fabrics or frames, place a weight (sold separately) on the base.
　It will be more stable.
When using a round frame larger than 20cm or thicker fabric, the grip may be damaged by the load.
　The grip may be damaged due to the load.
*The round frame, thread spool, and scissors in the image are for show only.

[Looseness of the round bar]
If the connection of the round bar becomes loose, apply thin cloth or masking tape to the end of the round bar.
or masking tape to the end of the round bar to adjust the gap.

[If the angle adjustment screw comes off]
If the screw comes off, insert the screw through the small hole on the opposite side of the mounting bracket (nut).
Insert the screw through the small hole on the opposite side of the mounting bracket (nut). If you install it from the opposite side, the nut will easily come off from the nut.
Please note that the nut will easily come off if it is installed from the opposite side.

Design registration No. 1664309

[Caution]
This product is made of natural wood.
There may be grain, knots, joints, and slight color shading.
Please note that over-tightening of screws will accelerate wear.
Product specifications are subject to change without notice for improvement.
Please understand this in advance.